Deep Clean

Deep Clean

Our Deep Clean for boat engines and bilges is our more thorough service. Following the same PREPARATION procedures as Quick Clean, we protect all sensitive areas both on and off the boat. 

We then hand scrub all surfaces with the appropriate EPA approved emulsifier, and allow it to ‘cure’.  This is followed by our “Soft Wash” using low pressure (1500 psi) steam and hot water.  This helps to enhance the effectiveness of the emulsifier while preserving the protective coating that is found on wires, cables, hoses, clamps, and metallic structures. We use a snub-nose wand and  small brushes that get into all the tight spaces for a super-clean result.

The client will specify the amount of rust removal and loose paint repair to be done.  Our Deep Clean service leaves the surfaces paint-ready for the final coat.